Cylinder Block Crankshaft Gear - Replacement (01-15) N14 Page 1-59 Use clean 15W-40 oil to lubricate the entire crankshaft to prevent rust. Crankshaft Gear - Replacement (01-15) Removal Only remove the gear when the crankshaft or the gear is damaged. Use a puller jaw, Part No. 3375839, and gear puller as- sembly, Part No. 3375834. NOTE: The crankshaft gear puller kit, Part No. 3375840, contains the gear puller jaw and the bridge assemblies re- quired for all Cummins engine models. Install the puller jaw and the bridge assembly. Use engine oil to lubricate the puller jackscrew. Caution: Do not exceed 475 [350 ft-lb] of torque when turning the jackscrew on the puller jaw.
Hold the pry bar steady. Turn the jackscrew. Remove the gear. Caution: Do not use a cutting torch. High temperature will damage the gear. Heat can be applied with caution to help remove the gear. Use a flat chisel and a hammer to remove the key. Use caution when removing the key to prevent crank damage.