Cylinder Block Camshaft Gear - Replacement (01-18) N14 Page 1-65 Measure the seven camshaft bushing journals. Camshaft Bushing Journal O.D. mm in 63.37 MIN 2.495 63.42 MAX 2.497 Replace the camshaft if the journal dimensions do not meet specifications. Measure the camshaft thrust washer. Camshaft Thrust Washer Thickness mm in 2.29 MIN 0.090 2.49 MAX 0.098 Replace the thrust washer if it does not meet specifica- tions. In an assembled engine, the camshaft end clearance must be 0.20 mm to 0.33 mm [0.008-inch to 0.013-inch]. Refer to Engine Assembly in Procedure 00-02. Refer to the Alternate Repair Manual, Bulletin No.
3379035, for procedures to magnetically check for cracks in the camshaft and gear. Camshaft Gear - Replacement (01-18) Removal Caution: Put a wooden block under the camshaft to avoid damage as the camshaft drops free from the cam gear. Install the camshaft and gear assembly in a hydraulic press. Put v-blocks under the gear. Make sure the v-blocks support the hub area of the gear.