Cummins — INSPECTION

Camshaft Gear - Replacement (01-18) Cylinder Block N14 Page 1-66 Caution: Do not use a heating torch to remove the gear. If you use a heating torch, a new gear must be installed. Push the shaft from the gear. NOTE: If the camshaft key is marked with an arrow, record the direction the arrow on the key is pointed (toward or away from the camshaft) for future reference. Use a flat chisel and a hammer to remove the camshaft key. Record the size (amount of offset) and the part number of the key. Cleaning Use solvent to clean the parts. Dry them with compressed air. Inspection Caution:

If the inside diameter of the gear is damaged or has fretting in excess of a 3.175 mm [0.125-inch] wide band, do not use the gear. Fretting or damage can result in gear movement on the camshaft nose which can cause camshaft nose failure. Visually inspect the camshaft gear for cracks, chipped, or broken teeth. Inspect the bore of the gear for fretting or burrs. NOTE: If the fretting, burrs, or raised material can not be removed with a fine crocus cloth, replace the gear. Inspect the gear keyway for burrs. Remove burrs with a fine crocus cloth. NOTE: If the keyway is damaged or the burrs can not be removed with a fine crocus cloth, the gear must be replaced.