Cummins — INSTALLATION

Camshaft Gear - Replacement (01-18) Cylinder Block N14 Page 1-68 Installation Change in Push Rod Travel At 19°BTDC mm [Inch] 3021601 None None None 3021595 0.15 [0.0060] Retard 0.07 [0.0030] 3021593 0.19 [0.0075] Retard 0.09 [0.0037] 3021592 0.29 [0.0115] Retard 0.14 [0.0057] 3021594 0.47 [0.0185] Retard 0.23 [0.0092] 3021596 0.65 [0.0255] Retard 0.32 [0.0127] 3021598 0.79 [0.0310] Retard 0.39 [0.0155] 3021597 0.99 [0.0390] Retard 0.49 [0.0195] 3021600 1.30 [0.0510] Retard 0.65 [0.0255] 3021599 0.29 [0.0115] Advance 0.14 [0.0057] 3024697* 0.65 [0.0255] Advance 0.32 [0.0127] * For CELECT™Engines Camshaft Keys NOTE:

The accompanying chart lists different camshaft key part numbers, the degree of offset, and the approximate injector timing change from nominal. 3/4 Inch Key Part No. Offset mm [Inch] Timing Change Use a plastic mallet to install the camshaft gear key. NOTE: If the same camshaft and gear are used again, use the same part number key as the one that was removed. Make sure the arrow on the key is pointing in the same direction as when it was removed. Refer to the engine dataplate and the Control Parts List Manual, Bulletin No. 3379133, for the correct key part number and key orientation. Put the camshaft in a vertical position with the gear fit area (nose) pointing up.

Apply Lubriplate T 105 or its equivalent to the camshaft gear fit area before installing the gear.