Cylinder Block Gear Cover - Cleaning and Inspection (01-19) N14 Page 1-69 Caution: Wear protective gloves when handling parts that have been heated to prevent personal injury. Heat the gear in an oven at 260°C [500°F] for a minimum of 1 hour. Remove the gear from the oven. NOTE: Install the gear on the camshaft within 30 seconds after it is removed from the oven. Caution: The timing marks and the part number on the gear must be facing away from the camshaft when the gear is installed to prevent engine damage. Align the gear keyway with the key in the camshaft, and install the gear. NOTE: Keep the camshaft in a vertical position with the gear up until the gear has cooled. Caution:
Do not use water or oil to reduce the cooling time. The gear can crack. Allow the air to cool the gear. If the gear does not seat against the locating shoulder on the camshaft, remove the gear and install it again. Use a feeler gauge to check the clearance between the camshaft gear and the shoulder. The clearance must not exceed 0.13 mm [0.005-inch]. Gear Cover - Cleaning and Inspection (01-19) Cleaning Use a mallet and a mandrel or a drift to remove the front crankshaft seal and the accessory drive seal.