Cylinder Block Gear Cover - Cleaning and Inspection (01-19) N14 Page 1-71 Measure the accessory drive seal bore. Accessory Drive Seal Bore I.D. mm in 80.962 MIN 3.1875 81.038 MAX 3.1905 NOTE: Replace the gear cover if the accessory drive seal bore is not within specifications. Measure the crankshaft seal bore. Crankshaft Seal Bore I.D. mm in 120.611 MIN 4.7485 120.688 MAX 4.7515 NOTE: Replace the gear cover if the crankshaft seal bore is not within specifications. Measure the accessory drive bushing inside diameter. Accessory Drive Bushing I.D. mm in 39.75 MIN 1.565 39.90 MAX 1.571 Replace the bushing if it is not within specifications.
Accessory Drive Bushing - Replacement Use gear cover bushing mandrel, Part No. ST-598, to remove the accessory drive bushing. Support the oppo- site side of the cover.