Cylinder Head - Service Tools Cylinder Head N14 Page 2-2 Cylinder Head - Service Tools The following special tools are recommended to perform procedures in Group 02. The use of these tools is shown in the appropriate procedure. These tools can be purchased from your local Cummins Authorized Repair Location. Tool No. Tool Description Tool Illustration Valve Seat Insert Tool ST-257 Cut valve seat counterbores for oversize valve seat inserts. Valve Spring Compressor Used to compress the valve spring while removing or installing the valve collets. Note: Single spring air-operated spring compressor, Part No. 3375960, (not shown) and multi-spring compressor, Part No.
ST- 1022, (not shown) used with Part No. ST-1026 (not shown) are also available. ST-448 Head Holding Fixture Hold and revolve the cylinder head during repair and assembly. ST-583 Valve Seat Grinding Machine Reface valve seats in the cylinder head. ST-685 Bead Cutting Tool Used to machine the beads in the lower injector sleeve seat area in the cylinder head. ST-788 Valve Guide Arbor Set ST-804 Used with valve seat insert tool, Part No. ST-257, and valve seat grinding machine, Part No. ST-685