Cylinder Head Cylinder Head - Service Tools N14 Page 2-3 Tool No. Tool Description Tool Illustration Fuel Passage Cleaning Brush Clean the internal fuel passages in the cylinder head. ST-876 Injector Sleeve Expander Roll and seal the upper portion of the injector sleeve in the cylinder head. ST-880 Injector Seat Cutter ST-884 Used to machine the injector sleeve seat to the correct depth to allow the specified injector protrusion through the cylinder head. Cylinder Head Water Test Fixture Used with water tester adapter plate, Part No. ST-1013, to hy- drostatic test for coolant leaks in the cylinder head. This fixture is designed for high volume usage. The test kit, Part No.
3377376, is available for low volume usage. ST-1012 Valve Spring Compressor Stand Use with compressor plate, Part No. ST-1026, to compress all valve springs on a cylinder head at the same time. ST-1022 Valve Spring Compressor Plate Use with valve spring compressor stand, Part No. ST-1022, to compress all valve springs on a cylinder head at the same time. ST-1026 Dowel Pin Extractor Pull the dowel pins and crosshead guides from the cylinder head. ST-1134 Magnetic Crack Detector ST-1166 Used to inspect cylinder heads and other ferrous castings that can not be magnafluxed for cracks. Note: Penetrant-type crack detection kit, Part No. 3375432, is also available.
This kit can be used to detect cracks in both ferrous and non-ferrous materials.