Cummins — DISASSEMBLY

Cylinder Head - Rebuild (02-02) Cylinder Head N14 Page 2-10 Visually inspect the cylinder head casting for cracks or damage. NOTE: If cracks or leaks in the cylinder head are suspected, refer to Cylinder Head - Pressure Testing (02-08). Visually inspect the valves for indications of leakage or burning. If indications of leakage or burning are found, the valves and the seats must be replaced or resurfaced. Refer to Cylinder Head - Rebuild (02-02). Cylinder Head - Rebuild (02-02) Disassembly Install the cylinder head in the head holding fixture, Part No. ST-583, as shown. NOTE: Do not install the cylinder head in the holding fixture if a valve spring compressor, Part No. ST-1022, is used.

Use valve spring compressor, Part No. ST-448, or its equivalent (refer to the Service Tools list) to compress the valve springs. NOTE: Install a wooden block between the valves and the head holding fixture to support the valves. NOTE: Valve spring stand, Part No. ST-1022, and the com- pressor plate, Part No. ST-1026, can be used to compress all eight springs at the same time.