Cylinder Head - Rebuild (02-02) Cylinder Head N14 Page 2-22 Use valve spring compressor, Part No. ST-448, or its equivalent (refer to the Service Tools list) to compress the valve springs. Install the new valve spring retainer collets. NOTE: Use new valve spring retainer collets when rebuilding the cylinder head. Use a mallet to gently hit the valve stems to make sure the valve collets are correctly seated in the spring retainer. Use valve vacuum tester, Part No. ST-1257, to vacuum test the valve seating. Refer to Cylinder Head - Vacuum Testing Valve Seating for Reuse (02-10). Cylinder Head Capscrews Caution: Do not use caustic or acid solutions to clean the cylinder head capscrews.
Use a petroleum-based solvent to clean the capscrews. Clean the capscrews thoroughly with a wire brush, with a wire wheel (soft), or use a non-abrasive bead blast to remove deposits from the shank and the threads.