Cummins — ASSEMBLY

Cylinder Head Cylinder Head - Rebuild (02-02) N14 Page 2-21 After grinding the valve seats, use a bristle brush to clean the inside diameter of the valve guides. Use solvent to clean the cylinder head. Dry with com- pressed air. Assembly Apply cup plug sealant, Part No. 3375068, to the outside diameter of the expansion plugs. Use expansion plug drivers to install the expansion plugs in the cylinder head. Refer to the chart below. Cup Plug Size Driver Tool No. 3/4-inch 3376815 1 inch 3376816 NOTE: Use the correct expansion plug driver to make sure the expansion plugs are installed to the correct depth in the cylinder head.

Drive the plug until the shoulder of the driver contacts the cylinder head. Use clean 15W-40 oil to prelubricate the valve stems. Install the valves in their original position in the cylinder head. NOTE: After the valves are installed, put the cylinder head on a flat surface so the cylinder head surface will not be damaged. Install the valve stem seal. Install the valve springs. Install the valve spring retainers.