Cummins — GRINDING THE VALVE SEATS

Cylinder Head - Rebuild (02-02) Cylinder Head N14 Page 2-20 Remove the valve, and measure the valve seat width and the seat contact area as indicated by the broken lines. The pencil or Dykem marks will be worn away where the valve contacted the seat. Valve Seat Width Limit mm in 1.60 MIN 0.063 3.18 MAX 0.125 Grind area (A) with a 60-degree stone and area (B) with a 15-degree stone to center the seat on the valve face and to obtain the valve seat width limits. The location of the broken lines on the valve face is the key to determining how much of each angle to grind.

If the broken lines are at the bottom of the valve face, the seat will require more grinding with the 60-degree stone than with the 15-degree stone. If the broken lines are at the top of the valve face, the seat will require more grinding with the 15-degree stone than with the 60-degree stone.