Cummins — GRINDING THE VALVE SEATS

Cylinder Head Cylinder Head - Rebuild (02-02) N14 Page 2-19 If the valve protrusion is out of limits, replace the old valve (A) with a new valve (B) before replacing the valve seat. If the protrusion is within limits with the new valve, pro- ceed using the new valve with the old seat. If the valve protrusion is still out of limits, even with the new valve (B), replace valve seat (C) with a new valve seat (D). After replacing the seat, check the valve protrusion again with the old valve (A) to determine if it can be reused. If not , proceed using new valve (B).

(A) = Old Valve (B) = New Valve (C) = Old Valve Seat (D) = New Valve Seat Check the valve seat contact area on the valve face to see if the valve seat contacts the center of the valve face. Use a pencil or Dykem W to put vertical marks on the face of the valve. Install the valve in the valve guide. Hold the valve against the valve seat. Rotate the valve backward and forward three or four times.