Cylinder Head - Rebuild (02-02) Cylinder Head N14 Page 2-18 Hold the drive unit in a vertical position, and use an up-and-down movement of 12.7 mm [0.50-inch] travel and light pressure to grind the insert. Remove the grinder unit from the arbor. Install eccentrimeter gauge (4), Part No. ST-685-4, on the arbor. Measure the valve seat to valve guide concentricity. Concentricity (Per 360 Degrees) mm in 0.09 MAX 0.0035 NOTE: If the valve seat concentricity does not meet the specifications, grind the valve seat again. If the specifica- tions can not be met, replace the valve seat insert. Refer to Cylinder Head - Replacing the Valve Seat Inserts (02-05).
Install reconditioned valves in their respective bores. Hold the valve firmly against the valve seat insert. Use a depth gauge, Part No. 3823495, to measure the valve protrusion. Valve Protrusion mm in - 0.63 MIN - 0.025 0.00 MAX 0.000