Cylinder Head Cylinder Head - Rebuild (02-02) N14 Page 2-17 Remove the injectors from the cylinder head and check the pattern of the blueing compound in the injector sleeve. The blueing pattern in the injector seating area (1) must be visible 360 degrees around the seating area. The injector bore seating width (2) must be a minimum of 1.52 mm [0.060-inch]. NOTE: If the injector protrusion is more than the maximum specified or if the injector sleeve blueing pattern does not meet the specifications given, the injector sleeve(s) must be replaced. Refer to Cylinder Head - Replacing the Injector Sleeves (02-07). Grinding the Valve Seats NOTE:
If the valve guide inside diameter exceeds the max- imum worn limit, replace the valve guide before grinding the valve seat. Use a valve seat grinding machine, Part No. ST-685, and valve guide arbor set, Part No. ST-663, when grinding the valve seat inserts. Install the valve guide arbor (1) in the valve guide with the arbor puller (2). NOTE: Rotate the arbor to make sure it is correctly installed. Install a valve seat grinding stone (3), Part No. ST-685-9, on the grinder unit. NOTE: The grinding stone must be the correct size and have the correct angle (2 1/4-inch diameter X 30-degree grinding angle). Install the grinder unit on the arbor. NOTE:
The grinding stone (3) must not touch the valve seat insert when the drive unit motor is started.