Cylinder Head - Rebuild (02-02) Cylinder Head N14 Page 2-16 Measure the width of the valve seat area of the valve seat inserts. Valve Seat Area (Width) mm in 1.60 MIN 0.063 3.18 MAX 0.125 NOTE: If the valve seat area is worn wider than the maximum specified, refer to ‘‘Grinding the Valve Seats’’ later in this procedure or to Cylinder Head - Replacing the Valve Seat Inserts (02-05). Perform the following steps to check the injector seating quality in the injector sleeve and to measure injector protrusion past the combustion face. Caution: Support the cylinder head to prevent damage to the injector tip which protrudes from the combustion face.
Apply a very light film of blueing compound to the outside diameter of the injector at the injector seat area. Blueing compound can effectively be applied with your finger or with a brush. Caution: Support the cylinder head combustion face so that it clears the work surface to prevent damage to the injector tips during installation. Install the injectors in the cylinder head without o-rings. Place a 1.2-inch thick block under the injector hold down clamp. This represents the rocker housing. Tighten the injector hold down capscrews. Torque Value: 54 [40 ft-lb] (STC and CELECT™) Turn the cylinder head over and use a depth gauge, Part No. 3823495, to measure the injector tip protrusion.
Injector Tip Protrusion mm in 1.47 MIN 0.058 1.82 MAX 0.072 NOTE: If the injector tip protrusion does not meet the spec- ifications given, the injector sleeve must be machined again.