Cylinder Head Cylinder Head - Rebuild (02-02) N14 Page 2-15 Use the N14 valve head checking tool to measure the head thickness of the valves. NOTE: Install the valve on the tool with the valve head contacting the tool as shown. If the valve head is even with, or extends beyond the end of the tool, the valve can be reground. If the valve head is below the end of the tool, the valve is not thick enough for regrinding. If a valve head checking tool is not available after re- grinding the valve seat surface, put the valve on a flat surface and measure the head thickness (1) at the outside diameter. Valve Head Thickness (at O.D.) mm in 2.90 MIN 0.114 NOTE:
If the valve head is thinner than the minimum spec- ified, the valve must be replaced. Visually inspect the valve guides for chips or cracks. Measure the inside diameter of the valve guides 12.7 mm [0.50-inch] from each end (1) and at the center as shown. Valve Guide I.D. (Installed) mm in 9.662 MIN 0.3804 9.738 MAX 0.3834 Measure the valve guide installed height. Valve Guide Height (Installed) mm in 31.75 MIN 1.250 32.76 MAX 1.290 NOTE: If damage is found or the valve guide(s) does not meet the limits specified, the valve guide(s) must be re- placed. Refer to Cylinder Head - Replacing the Valve Guides (02-03).