Cummins — INSPECTION

Cylinder Head - Rebuild (02-02) Cylinder Head N14 Page 2-14 Use valve spring tester, Part No. 3375182, to measure the valve spring load at the valve spring working height. Working Height (B) Valve Spring Part No. mm Limit in. 3070460 56.89 Nominal 2.240 Load for Working Height (C) Valve Spring Part No. N Limit lbf 3070460 1067 MIN 240 1156 MAX 260 NOTE: If the valve spring load for the working height is less than the minimum specified, the valve spring(s) must be replaced. Inspection Visually inspect the valve spring retainers and the valve stem seals for damaged or worn areas. Remove the valve stem seals from the valve stem seal retainers, and visually inspect for damaged or worn areas.

Discard unserviceable parts. Visually inspect the valves for damage. Visually inspect the collet grooves for wear. Replace damaged valves or valves with worn collet grooves. Measure the outside diameter of the valve stem. Stem O.D. mm in 9.59 MIN 0.3775 9.63 MAX 0.3793