Cylinder Head Cylinder Head - Replacing the Valve Guides (02-03) N14 Page 2-25 Immediately after cleaning and inspecting, apply a film of clean engine lubricating oil to capscrews that are to be used again. Cylinder Head - Replacing the Valve Guides (02-03) Disassembly Use a valve guide driver, Part No. 3376398, (1) and an arbor press to remove the old valve guides (2). Cleaning Use a flexible brush and solvent to clean the valve guide bores in the cylinder head. Dry with compressed air. Inspection Measure the inside diameter of the valve guide bore in the cylinder head. Valve Guide Bore I.D. mm in 19.05 MIN 0.750 19.07 MAX 0.751 NOTE:
If the valve guide bore is worn larger than the max- imum specified, the valve guide bore can be machined and 0.25 mm [0.010-inch] or 0.38 mm [0.015-inch] oversize valve guides installed. Refer to the Alternative Repair Manual, Bulletin No. 3379035.