Cummins — ASSEMBLY

Cylinder Head - Replacing the Injector Sleeves (02-07) Cylinder Head N14 Page 2-34 Caution: Support the cylinder head to prevent damage to the injector tip that protrudes from the combustion face. Apply a very light film of blueing compound to the outside diameter of the injector at the injector seat area. Blueing compound can effectively be applied with your finger or with a brush. Install the injector in the cylinder head without o-rings. Place a 1.2-inch thick block under the injector hold down clamp. This represents the rocker housing. Tighten the injector hold down capscrews. Torque Value: 54 [40 ft-lb] STC and CELECT™ Turn the cylinder head over and use a depth gauge, Part No.

3823495, to measure the injector tip protrusion. Injector Tip Protrusion mm in 1.47 MIN 0.058 1.82 MAX 0.072 NOTE: If the injector tip protrusion does not meet the spec- ifications given, the injector sleeve must be machined again. Remove the injectors from the cylinder head, and check the pattern of the blueing compound in the injector sleeve.