Cylinder Head Cylinder Head - Pressure Testing (02-08) N14 Page 2-35 The blueing pattern in the injector seating area (1) must be visible 360 degrees around the seating area. The injector bore seating width (2) must be a minimum of 1.52 mm [0.060-inch]. NOTE: If the injector protrusion is more than the maximum specified or if the injector sleeve blueing pattern does not meet the specifications given, the injector sleeve(s) must be replaced. Refer to Cylinder Head - Replacing the Injector Sleeves (02-07). NOTE: Inspect the cylinder head for leaks after the new injector sleeves have been installed. Refer to Cylinder Head - Pressure Testing (02-08).
Cylinder Head - Pressure Testing (02-08) Caution: Do not pressure test the cylinder head with the valves and the valve springs installed. If the cylinder head is assembled, the valve guides and the valve stems can be damaged because they cannot be dried thor- oughly. Remove the valves and the valve springs as follows: 1. Use valve spring compressor stand, Part No. ST-1022, and valve spring compressor plate, Part No. ST-1026. 2. Mark each valve as it is removed to identify its location in the cylinder head. Install two injector sleeve holding tools, Part No. ST-1179, in each cylinder head.
ST-1179 Injector Sleeve Holding Tool Description (1) Hex Head Capscrew (1) (2) Flat Washer (1) (3) ST-1179-2 Anvil (1) (4) 3377347 Nut and Plug Assembly (1) (5) Hex Head Capscrew (1)