Cummins — CYLINDER HEAD - PRESSURE TESTING

Cylinder Head - Pressure Testing (02-08) Cylinder Head N14 Page 2-36 Tighten the injector sleeve holding tool capscrew. Torque Value: 5 [45 in-lb] 10 [90 in-lb] 15 [130 in-lb] Install the cylinder head in a hydrostatic tester, Part No. ST-1012, and a hydrostatic tester adapter plate, Part No. ST-1013. Connect a regulated air supply hose to the test fixture plate. Apply 275 kPa [40 psi] air pressure. Use a hoist to put the cylinder head in a tank of warm water heated to 60°C [140°F]. Completely submerge the cylinder head in the water. Visually inspect for air bubbles rising from the water. If air bubbles are seen, repair the leaking area.