Cylinder Head Cylinder Head - Magnetic Particle Checking (02-09) N14 Page 2-37 Remove the test equipment. Dry the cylinder head with compressed air. Assemble the cylinder head. Refer to ‘‘Assembly’’ under Cylinder Head - Rebuild (02-02). A. Valve B. Valve Stem Seal C. Valve Spring D. Valve Spring Retainer E. Collets Cylinder Head - Magnetic Particle Checking (02-09) Caution: The cylinder head must be thoroughly cleaned after using the magnetic crack detector, Part No. ST- 1166, so that all iron fragments are removed. Use the magnetic crack detector, Part No. ST-1166, to find cracks in the areas around the valves and the injectors. Fill the powder spray bulb one-third full of metal powder.
Put the magnetizing head on the cylinder head combus- tion surface as shown to check for cracks that run across the head.