Cylinder Head Valve Crosshead - Cleaning and Checking for Reuse (02-12) N14 Page 2-41 Valve Crosshead - Cleaning and Checking for Reuse (02-12) Cleaning Use solvent to clean the crosshead. Dry with compressed air. Inspection Visually inspect the rocker lever contact pad for wear, cracks, or damage. Visually inspect the valve stem contact areas for damage. Measure both valve stem pocket depths from the valve stem pocket to the rocker pad face (1). Stem Pocket to Pad Face mm in 11.53 MIN 0.454 12.55 MAX 0.494 On a given crosshead, the stem pocket to pad bore di- mension (1) on one end must fall to within 0.020 inch of the dimension (2) on the opposite end.
In a cylinder head assembly, the crosshead to valve spring retainer must be a minimum of 0.020 inch. NOTE: If damaged parts are found or if the stem bore or pocket depth are not within the limits specified, the parts must be replaced. If cracks are suspected, refer to Valve Crosshead - Magnetic Crack Inspection (02-13).