Rocker Lever - Cleaning and Inspection for Reuse (03-01) Rocker Lever Housing Assembly N14 Page 3-8 Rocker Lever - Cleaning and Inspec- tion for Reuse (03-01) Disassembly Loosen the valve and injector adjusting screw lock nuts on each rocker lever. Turn the adjusting screws counterclockwise until the rocker levers are loose. Caution: Do not attempt to remove or install the rocker lever shaft assemblies without backing out the adjusting screws. If not loosened, damage to the dowel pins and ring dowels can occur. Remove the rocker lever shaft capscrews and the rocker lever shaft assemblies. NOTE:
To prevent increased wear, mark each rocker lever as it is removed so it can be installed back in its original location. Remove the rocker levers from the shaft. Remove the lock nuts and the adjusting screws from the rocker lever. NOTE: To prevent increased wear, mark each adjusting screw as it is removed so it can be installed back in its original rocker lever. Cleaning and Inspection Use steam or solvent to clean the rocker lever shaft. Dry with compressed air.