Rocker Lever Housing Assembly - Cleaning and Inspection for Reuse (03-05)Rocker Lever Housing Assembly N14 Page 3-18 Visually inspect the rocker lever shaft dowel rings (1), the dowel pins (2), and the brass cup plug (3). Replace if necessary. Use service tool, Part No. 3823821, to remove the dowel pins and dowel rings. Refer to Ring and Pin Dowel - Replacement (03-07). Installation Install two o-rings (1) on each of the two water tubes (2). Install one o-ring (1) on each of the two water plugs (3). Apply a non-petroleum based lubricant such as soap or vegetable oil to the o-rings on the tubes and plugs and to the bores in the rocker housings.
Install the water tubes (A) in the front of the No. 2 and No. 3 rocker lever housings. Install the plugs (B) in the front to the No. 1 rocker lever housing and in the rear of the No. 3 rocker lever housing.