Ring and Pin Dowel - Replacement (03-07) Rocker Lever Housing Assembly N14 Page 3-20 Ring and Pin Dowel - Replacement (03-07) Removal Select the proper size ring dowel remover and insert the threaded end into the ring dowel to be removed. Tighten the hexagon nut until snug. Mount the slide ham- mer onto the dowel remover. Use the slide hammer to remove the ring dowel. To remove a 1/4-inch straight dowel, place the 6.35 mm [1/4-inch] dowel remover on the dowel to be removed. It may be necessary to turn the dowel remover to clear unmachined casting.