Cummins — INSTALLATION

Metri-Pack Pass Through Connector - Replacement (03-08) Rocker Lever Housing Assembly N14 Page 3-22 Disconnect the actuator harness from the pass through connector. Remove the capscrew. Cut and remove the plastic wire tie that holds the actuator harness to the pass through connector. Pull the pass through from the rocker box housing. Disconnect the injector solenoid wires from the pass through connector. Installation Install the new pass through connector. Connect the pass through connector to the injector solenoid wires. Insert the pass through into the rocker lever housing. Tighten the capscrew. Torque Value: 15 [11 ft-lb] Connect the actuator harness to the pass through.

Install a new plastic wire tie, Part No. 3062329.