Cummins — INSPECTION

Cam Follower Assembly - Cleaning and Inspection for Reuse (04-01) Cam Follower Assembly N14 Page 4-6 Measure the cam follower roller side clearance. Roller Side Clearance mm in 0.23 MIN 0.009 0.61 MAX 0.024 NOTE: If the roller side clearance is not within these spec- ifications, the roller must be replaced. Refer to Cam Follower Lever - Roller Replacement (04-03). Use a dial indicator to measure the cam follower to roller pin clearance. Roller to Pin Clearance mm in 0.08 MIN 0.003 0.20 MAX 0.008 NOTE: If the roller to pin clearance is not within these spec- ifications, the roller and the pin must be replaced. Refer to Cam Follower Lever - Roller Replacement (04-03).

Visually inspect the sockets for excessive wear or dam- age. A good even seating pattern must be seen when inspect- ing the cam follower socket. When parallel grooves and scratches are observed or the contact area extends into the oil hole chamfer of the socket, the worn socket must be replaced. NOTE: If excessive wear or damage is found in the sockets, the sockets must be replaced. Refer to Cam Follower Socket - Replacement (04-04). Do not use push rods with worn balls in cam followers with new sockets. Refer to Push Rod - Cleaning and Inspection for Reuse (04-05).