Cummins — DISASSEMBLY

Cam Follower Assembly Cam Follower Assembly - Rebuild (04-02) N14 Page 4-7 Use clean 15W-40 oil to check the oil flow through the cam followers. Cam Follower Assembly - Rebuild (04-02) Disassembly Remove the two locking screws. NOTE: Each cam follower housing assembly consists of two shaft assemblies secured in a common center support with two locking screws. Caution: Do not push the cup plug through the cam follower lever shaft bores. The bores will be damaged. Use expansion plug driver, Part No. 3376813, and a mallet to remove the cup plugs. Push the cup plug and the shafts through one end of the housing until the cup plug on the opposite end of the housing is pushed from the housing bore.

Push the shafts the opposite direction through the hous- ing until the cup plug on the other end of the housing is pushed from the housing bore.