Cam Follower Assembly Cam Follower Lever - Roller Replacement (04-03) N14 Page 4-13 Install the cam follower lever into an arbor press. Caution: Use the largest feeler gauge that will fit be- tween the roller and the lever to prevent leg deflection when removing the roller pin. This will reduce shaving of the bronze roller pin and prevent leg breakage. Install a feeler gauge between the roller and the leg of the lever. Push the roller pin from the cam follower lever. Discard the unacceptable rollers and all the roller pins. Cleaning Use a 240 grit, or finer, emery cloth to remove any burrs from the edges of the pin bore holes. NOTE: Do not burnish the inside diameter of the pin bore holes.
Use solvent to clean the levers. Dry with compressed air. Inspection - Magnetic Crack Refer to the Alternate Repair Manual, Bulletin No. 3379035, for procedures to magnetically check for cracks in the cam follower levers. Inspection - Dimensional Measure the inside diameter of the cam follower lever roller pin bore. Valve Lever Roller Pin Bore I.D. mm in 12.674 MIN 0.4990 12.687 MAX 0.4995 Injector Lever Roller Pin Bore I.D. mm in 19.042 MIN 0.7497 19.055 MAX 0.7502