Cummins — DISASSEMBLY

Cam Follower Lever - Roller Replacement (04-03) Cam Follower Assembly N14 Page 4-12 Install the levers and the shafts in the housings. NOTE: To prevent increased wear, install the cam follower levers and the shafts back in their original location in the housing. Install the cup plugs in the housings as follows: 1. Install two temporary capscrews in the shafts to pre- vent breaking the locking screws. 2. Put cup plug sealant, Part No. 3375068, on the cup plugs. 3. Use expansion plug driver (1), Part No. 3376813, to install the cup plugs. Install to a depth of 0.025 inch ± 0.010 inch below flush. 4. Remove the two temporary capscrews, and install the two locking screws in the shafts.

Torque Value: 2 [15 in-lb] NOTE: The heads of the locking screws must be flush or below flush with the gasket surface of the cam follower housing. Cam Follower Lever - Roller Replace- ment (04-03) Disassembly Install the cam follower lever into a vise with brass jaws. The cam follower lever does not have a through hole in which to drive the roll pin for removal. Use a hammer and cam follower pin driver, Part No. 3823592, or a suitable pin punch to drive the roll pin out of the lever (1) and into the roller pin (2).