Cummins — ASSEMBLY

Cam Follower Assembly Cam Follower Lever - Roller Replacement (04-03) N14 Page 4-15 Assembly NOTE: The roller pin must be installed correctly to make sure the cam follower roller and the roller pin are supplied with oil. Inspect the new roller pin as shown to determine the oil feed pass (1) and the alignment hole (2) locations. The oil feed passage is drilled approximately two-thirds of the way through the pin. The alignment hole is drilled completely through the pin. Use a grease pencil or a similar marker to draw a line on the side of the roller pin that is perpendicular to the alignment hole. NOTE: The line will help align the roller pin correctly in the cam follower lever.

Install the cam follower lever in an arbor press with the leg with the alignment hole towards the top. Install the roller into the cam follower lever. Caution: Use the largest feeler gauge that will fit be- tween the roller and the lever to prevent leg deflection when installing the roller pin. This will reduce shaving of the bronze roller pin and prevent leg breakage. Install a feeler gauge between the roller and the leg of the lever. Valve cam follower lever (A) Injector cam follower lever (B)