Cummins — ASSEMBLY

Cam Follower Lever - Roller Replacement (04-03) Cam Follower Assembly N14 Page 4-16 Caution: The cam follower roller pin must be installed with the oil feed hole (1) positioned towards the top of the cam follower lever (2). NOTE: Freezing the roller pin will simplify its installation. Use clean 15W-40 oil to lubricate the roller pin. Install the roller pin. Make sure the pin alignment hole (1) is correctly aligned with the alignment hole (2) in the lever before pushing the roller pin into the cam follower lever. Install a new roll pin into the cam follower lever. Drive the roll pin in until it is approximately 1.5 mm [0.06- inch] below the surface of the cam follower lever.

Turn the roller by hand to make sure it rotates freely.