Cam Follower Assembly Cam Follower Socket - Replacement (04-04) N14 Page 4-17 Measure the cam follower roller side clearance. Roller Side Clearance mm in 0.23 MIN 0.009 0.61 MAX 0.024 NOTE: If the roller does not rotate freely or the clearance is not within specification, disassemble and check the roller pin and the lever for damage. The pin can not be used again. Cam Follower Socket - Replacement (04-04) NOTE: This procedure assumes that the roller is removed. Use a pin punch to remove the socket. NOTE: The roller must be removed to allow access to the socket removal hole. Refer to Cam Follower Lever - Roller Replacement (04-03).
The N14 valve and injector cam follower socket has an identification groove around the outside diameter and two marks 180 degrees apart on top of the socket. Measure the parts. (1) Socket O.D. mm in 19.062 MIN 0.7505 19.088 MAX 0.7515 (2) Lever Bore I.D. mm in 19.025 MIN 0.7490 19.050 MAX 0.7500