Push Rod - Cleaning and Inspection for Reuse (04-05) Cam Follower Assembly N14 Page 4-18 Caution: Support as shown to prevent cracks in the cam follower. An old roller can be used to support the lever. Use a brass drift or a used push rod end (2). Use an arbor press. Install the new socket. The socket must touch the bottom of the bore in the lever. Push Rod - Cleaning and Inspection for Reuse (04-05) Cleaning Use solvent to clean the push rods. Dry with compressed air. Inspection Inspect for engine oil in the push rods as follows: 1. Hold the push rod horizontally and drop it from a height of 6 inches onto a concrete floor or a metal surface. 2.
The push rod can be used if a ringing sound is heard. 3. If a dull (or non-ringing) sound is heard, the push rod contains engine oil and must be discarded. Inspect the straightness of the push rod by rolling it on a level bench. Replace the push rod if it is bent. Do not use a bent push rod.