Injectors and Fuel Lines Fuel Tubes, Fittings, and Mounting Parts - Cleaning and Inspection for Reuse (06-05) N14 Page 6-9 Fuel Tubes, Fittings, and Mounting Parts - Cleaning and Inspection for Reuse (06-05) Cleaning Use solvent to clean the fuel tubes, fittings, and parts. Dry with compressed air. Inspection Visually inspect the fuel tubes for cracks or locations where the tubing is crushed. Do not attempt to repair fuel tubing. Visually inspect the injector hold down clamps for cracks or other damage. NOTE: If cracked or damaged parts are found, the parts must be replaced.