Cummins — DISASSEMBLY

Lubricating Oil System Lubricating Oil Pump - Rebuild (07-06) N14 Page 7-11 Inspection Turn the main drive gear by hand to check the internal gears for freedom of rotation. Visually inspect the gears for cracked or broken teeth. Visually inspect the bushings for excessive wear or dis- coloration due to overheating or seizure of the shafts. Measure the drive shaft end clearance with a dial indi- cator located at the end of the lubricating oil pump drive shaft. Drive Shaft End Clearance mm in 0.10 MIN 0.004 0.28 MAX 0.011 NOTE:

If the main drive gear does not turn freely by hand, cracked or broken teeth are found, or the shaft end clear- ance is not within the specifications given, the oil pump must be replaced or rebuilt. Refer to Lubricating Oil Pump - Rebuild (07-06). Lubricating Oil Pump - Rebuild (07-06) Disassembly Remove the main oil pressure regulator as follows: 1. Remove the capscrew (1) and the retainer plug (2). 2. Remove the spring (3) and the regulator plunger (4). NOTE: Carefully remove the capscrew (1). The pressure regulator spring (3) is under compression.