Lubricating Oil Pump - Cleaning and Inspection for Reuse (07-05) Lubricating Oil System N14 Page 7-10 Remove the dipstick and scribe a mark across the dipstick. Mark the level with an NOTE: The dipstick will break if the scribe mark is too deep. NOTE: Cut the new dipstick off approximately 38 mm [1.5 inches] below the oil level mark. Install the dipstick into the dipstick tube housing. Use clean 15W-40 oil to fill the oil pan to the specified oil pan capacity level. Refer to the preceding oil pan capacity table for the oil required. Remove the dipstick and scribe a mark across the dipstick. Mark the oil level with an NOTE: The dipstick will break if the scribe mark is too deep.
Lubricating Oil Pump - Cleaning and Inspection for Reuse (07-05) Cleaning Remove the cover and the gasket from the power steer- ing pump mounting flange. Use a gasket scraper to remove the gasket material from the gasket mating surfaces. Use solvent to clean the lubricating oil pump. Dry with compressed air.