Cummins — LUBRICATING OIL DIPSTICK - CALIBRATION

Lubricating Oil System Lubricating Oil Transfer Tube - Cleaning and Inspection for Reuse (07-02) N14 Page 7-9 Lubricating Oil Transfer Tube - Clean- ing and Inspection for Reuse (07-02) Cleaning Use solvent to clean the lubricating oil transfer tube and the mounting flanges. Dry with compressed air. Inspection Visually inspect the tube and the flanges for cracks, cor- rosion, or other damage. NOTE: If cracks or damage are found, the transfer tube must be replaced. Lubricating Oil Dipstick and Dipstick Tube - Cleaning and Inspection for Reuse (07-03) Cleaning Remove all gasket material from the hand hole cover gasket sealing surface.

Use solvent to clean the dipstick, dipstick tube, and the hand hole cover. Dry with compressed air. Inspection Visually inspect the dipstick tube and the hand hole cover for cracks or damage. Visually inspect the dipstick tube angle. NOTE: If cracks or damage are found or if the dipstick tube does not angle down into the oil pan, the damaged parts or the dipstick tube must be replaced. Lubricating Oil Dipstick - Calibration (07-04) While the engine is installed in chassis, install the dipstick in the dipstick tube housing. Use clean 15W-40 oil to fill the oil pan to the specified oil pan capacity level. Oil Pan Capacity Liters U.S. Gallons 30 LOW 8.0 35 HIGH 9.5