Cummins — INSPECTION

Lubricating Oil System Lubricating Oil Pump - Rebuild (07-06) N14 Page 7-13 Cleaning Clean the gasket material from the lubricating oil pump body and the cover. Use solvent to clean the lubricating oil pump parts. Dry with compressed air. Use an acetylene torch tip cleaner or its equivalent that is 1.02 mm [0.040-inch] or less in diameter to clean the orifice in the cover. NOTE: The diameter of the orifice is 1.02 mm [0.040-inch]. Do not attempt to drill out the orifice or use a larger diameter wire to clean the orifice. Inspection Visually inspect the cover and gear pockets in the body for scratches or other damage.

If the marks on the cover or in the body can be felt with your fingernail, the part must be replaced. Visually inspect the oil pump body and cover for cracks or damage. Visually inspect the oil pump gears for worn or damaged teeth. NOTE: Cracked, worn, or damaged oil pump parts must be replaced.