Cummins — ASSEMBLY

Lubricating Oil System Lubricating Oil Pump - Rebuild (07-06) N14 Page 7-17 Install the oil pump body and the drive shaft assembly in an arbor press. Support the end of the drive shaft, and press the main drive gear onto the shaft. NOTE: At this stage of assembly, there must not be more than 0.30 mm [0.012-inch] end clearance between the main drive gear and the oil pump body. Use a dial indicator lo- cated on the end of the lubricating oil pump drive shaft to make this measurement. Lubricate the inside diameter of the bushings in the driven gear with clean 15W-40 oil. Install the driven gear on the shaft. Install the high oil pressure relief valve as follows: 1.

Install locating plate, Part No. 3376013 (in DFC pres- sure valve fixture, Part No. 3376011) on the oil pump body. NOTE: Use two 5/16 - 18 X 1 1/4-inch capscrews. Do not tighten the capscrews at this time. Install the large diameter of valve mandrel, Part No. 3376012, through the locating plate into the pressure limit valve bore in the oil pump body. Tighten the capscrews, and remove the mandrel.