Cummins — ASSEMBLY

Lubricating Oil Pump - Rebuild (07-06) Lubricating Oil System N14 Page 7-16 Use valve spring tester, Part No. 3375182, to determine if the spring is defective. NOTE: Compress the spring to a height of 46.23 mm [1.820 inches]. The force required must be: Minimum: 98 Newtons [22 lbf] Maximum: 116 Newtons [26 lbf] NOTE: If the force required to compress the spring is not within the specifications given, the spring must be replaced. Visually inspect the high pressure relief valve retainer plug, the valve disc, the washer, and the valve spring for damage. Use valve spring tester, Part No. 3375182, to measure the relief spring tension. NOTE:

Compress the spring to a height of 29.08 mm [1.145 inches]. The force required must be: Minimum: 262 Newtons [59 lbf] Maximum: 320 Newtons [72 lbf] NOTE: If the force required to compress the spring is not within the specifications given, the spring must be replaced. Assembly Use clean 15W-40 oil to lubricate the drive shaft. Install the drive shaft, from the gear pocket side of the oil pump body, into the drive shaft bore. Use clean 15W-40 oil to lubricate the inside diameter of the oil pump main drive gear.