Lubricating Oil System Lubricating Oil Pump - Rebuild (07-06) N14 Page 7-15 Measure the outside diameter of the drive and the driven shafts in the bushing contact area. Shaft O.D. mm in 22.20 MIN 0.8745 22.22 MAX 0.8750 NOTE: Shafts that are damaged or worn smaller than the minimum given must be replaced. Refer to Lubricating Oil Pump Drive Gear or Shaft - Replacement (07-09). Visually inspect the main drive gear for cracks, chipped, or broken teeth. Inspect the bore of the gear for scoring or other damage. Measure the inside diameter of the main drive gear bore. Main Drive Gear Bore I.D. mm in 22.161 MIN 0.8725 22.187 MAX 0.8735 NOTE:
If the main drive gear bore is worn beyond the max- imum limit, the drive gear must be replaced. Visually inspect the main oil regulator plunger for scratches or scoring. NOTE: If scratches are deep enough to be felt with a fin- gernail, the plunger must be replaced. Visually inspect the spring for damaged or broken coils.