Water Header Covers - Removal Engine Disassembly (00-01) N14 Page 0-16 Water Header Covers - Removal Remove the six capscrews from each of the two water header covers. Remove the covers, and discard the gaskets. Engine - Installation on the Rebuild Stand NOTE: Use engine rebuild stand, Part No. 3375194, and the adapter plate, Part No. 3375013. Use six 5/8-11 X 1 3/4-inch grade 5 capscrews to install the adapter plate to the rebuild stand. Torque Value: 102 [75 ft-lb] The engine stand adapter plate attaches to the cylinder block at the capscrew locations shown. Check the condition of the threads in the cylinder block before attempting to mount the engine on the engine stand.
Clean the threads in the cylinder block, and repair any damaged threads.