Cummins — DISASSEMBLY

Lubricating Oil Cooler Assembly - Rebuild (07-11) Lubricating Oil System N14 Page 7-28 Assembly Use gear and spacer mandrel, Part No. ST-1157, to install the driven shaft into the oil pump body as follows: 1. Lubricate the large outside diameter of the driven shaft with clean 15W-40 oil. 2. Install the large outside diameter of the driven shaft into the bore in the oil pump body. 3. Use an arbor press and the gear and spacer mandrel to push the shaft into the bore. 4. Measure the amount of shaft protrusion above the oil pump cover mounting surface.

Driven Shaft Protrusion mm in 17.90 MIN 0.705 18.67 MAX 0.735 Lubricating Oil Cooler Assembly - Rebuild (07-11) Disassembly Remove the four filter head 12 point capscrews and the filter head. Remove the coolant filter shutoff valve retaining capscrew and washer. Remove the shutoff valve and the o-ring.