Cummins — INSPECTION

Lubricating Oil System Lubricating Oil Pump Driven Shaft - Replacement (07-10) N14 Page 7-27 Assembly Use clean 15W-40 oil to lubricate the drive shaft. Use spacer mandrel, Part No. ST-1157, and an arbor press to push the drive gear onto the drive shaft. If the spacer mandrel is not available, install the gear onto the shaft to the following dimension as measured from the end of the shaft. Installed Depth mm in 27.43 MIN 1.080 27.69 MAX 1.090 Lubricating Oil Pump Driven Shaft - Replacement (07-10) Disassembly Install the oil pump body in an arbor press with the cover mounting surface of the body facing down. Use a mandrel to push the driven shaft from the lubri- cating oil pump body.

Inspection Visually inspect the driven shaft bore in the lubricating oil pump body for damage. Measure the inside diameter of the driven shaft bore. Driven Shaft Bore I.D. mm in 22.263 MIN 0.8765 22.289 MAX 0.8775 NOTE: If the shaft bore diameter is not within specifications, the pump body must be replaced. Measure the driven shaft outside diameter in the press fit area. Driven Shaft Press Fit Area O.D. mm in 22.301 MIN 0.8780 22.314 MAX 0.8785