Cummins — INSPECTION

Lubricating Oil Pump Drive Gear or Shaft - Replacement (07-09) Lubricating Oil System N14 Page 7-26 Measure the inside diameter of the new bushings in the driven gear. Bushing I.D. (New) mm in 22.28 MIN 0.877 22.30 MAX 0.878 NOTE: The bushings used in the driven gear are finished bushings and do not require cutting. If the bushing inside diameter is not within the specifications given after instal- lation, the bushing must be replaced. Lubricating Oil Pump Drive Gear or Shaft - Replacement (07-09) Disassembly To remove the drive shaft from the drive gear, do the following: 1. Install the shaft and the gear assembly in an arbor press. 2. Use a mandrel to push the shaft from the gear.

Inspection Visually inspect the bore in the drive gear for damage. Measure the inside diameter of the bore in the drive gear. Drive Gear Bore I.D. mm in 22.187 MIN 0.8735 22.200 MAX 0.8740 NOTE: If the bore inside diameter is not within specifica- tions, the gear must be replaced. Visually inspect the drive shaft for damage. Measure the outside diameter of the drive shaft. Drive Shaft O.D. mm in 22.212 MIN 0.8745 22.225 MAX 0.8750 NOTE: Shafts that are damaged or worn smaller than the minimum given must be replaced.