Lubricating Oil System Lubricating Oil Pump Driven Gear Bushing - Replacement (07-08) N14 Page 7-25 Measure the inside diameter of the bushings in the oil pump body and the cover. Bushing I.D. (New) mm in 22.28 MIN 0.877 22.30 MAX 0.878 NOTE: Bushings that do not meet the specifications given must be replaced. Lubricating Oil Pump Driven Gear Bushing - Replacement (07-08) Disassembly Use bushing mandrel, Part No. ST-1158, to remove the worn or damaged bushings from the driven gear. Inspection Visually inspect the bushing bore in the driven gear for damage. Measure the inside diameter of the bushing bore in the oil pump driven gear. Bushing Bore I.D.
mm in 25.387 MIN 0.9995 25.413 MAX 1.0005 NOTE: If the bushing bore inside diameter is not within specifications, the gear must be replaced. Assembly Use bushing mandrel, Part No. ST-1158, to push the new bushings into the driven gear. NOTE: The bushings must be installed level with or to a maximum of 0.51 mm [0.020-inch] below the surface of the driven gear.