Lubricating Oil Pump Body and Cover Bushing - Replacement (07-07) Lubricating Oil System N14 Page 7-24 Use a cutting oil to lubricate and cool the bit while cutting the bore in the bushing. Stop the drill motor when the stop collar on the drive shaft is against the body of the boring tool. Move the feed control lever to the position. Pull the drive shaft up to remove the tool bit from the bushing. Remove the boring tool from the oil pump body. NOTE: The tool bit must move through the slot in the guide bushing. Do not allow the tool bit to hit against the guide bushing. Remove the cover from the oil pump body. Remove the guide bushing from the oil pump body.
Use solvent to clean the oil pump body and the cover. Dry with compressed air. NOTE: All metal particles must be cleaned from the oil pump body and the cover.